Renetech Sdn Bhd
28-G & 28-1, Jalan Suria Puchong 4,
Pusat Perniagaan Suria Puchong,
47110 Puchong,
Selangor, Malaysia.
+6012-234 0081

SR-500

SR-500 THINKY MIXER (Non Vacuum) Solder Paste Mixer THINKY MIXER Mixer


Special purpose machine that can optimize temperature and viscosity preparations and dispersion and deaeration of solder paste at the same time
  • Can immediately prepare cold stored solder paste without bringing it back to room temperature
  • By optimizing the mixing recipe, viscosity preparation and temperature preparation for solder paste is easy.
  • Removes large air bubbles in the paste, which are considered the cause of solder paste defects.
  • Handles commercial 500g solder paste containers as is
  • Restirs and redisperses solder paste that has been used
  • Supports solder paste in syringes by using the optional adapter
Feature
Can prepare uniform viscosity in a short time for solder paste just taken from cold storage without bringing it back to room temperature. Metal particles with high specific gravity such as solder particles settle to the bottom of containers in cold storage and cause differences in material viscosity. The SR-500 regulates the viscosity of solder paste in a short time, with uniform viscosity from top to bottom. Also, because it can remove air bubbles thought to cause spattering of solder balls, it contributes to reducing the defect rate.

Specification

Unit Dimensions/ Unit weight H390 ×W300×D340£¨mm£© Approx. 18kg
Maximum Capacity*1
*1£ºTotal mass to mount on the cup holder, including materials, containers, and adapters.
680g
Standard Container*2
*2£ºContact us because the actual volume of mixing may vary depending on the containers, materials, and conditions.
150 ml resin container
Power Supply Voltage: Single-phaseAC 120 V ± 10 %, 50/60 HzPower consumption:Approx. 50 VA (standby)Max 900 VA (operation)
Accessories Instruction Manual × 1,AC cable (including 3P adapter) × 1,150 ml container × 3,Adapter for HDPE 150 ml container × 1(including 1 O-ring)Silicon rubber sheet × 1,O-ring for fine adjustment × 11 metal fitting is attached to the unit rear to release the lid lock, in case of power failure.

Please leave your enquiry here, we will reply as soon as possible.
Name*  
Company Name  
Product Interested  
Quantity  
Email*  
Contact No.*  
Attachment  
*only support gif, jpeg, jpg, png, pdf
Messages*  

Switch to Mobile Version